Changing Harness Height; For Newborns; For A Larger Baby - CYBEX ONYX 2011 Owner's Manual

adjusting the Harness

Changing Harness Height

This stroller features three Shoulder Harness
Positions for the safety and comfort of your
child.
aLWaYS USe a harness position located
aBOVe the child's shoulders. If all harness
positions are above the child's shoulders,
use the one closest to the shoulders.
1. Begin by pulling the Adjustment Strap snug.
2. At the back of the stroller, and under the
lower part of the seat cover, locate the
metal Splitter Plate that holds both of the
Shoulder Straps and unhook both straps.
3. From the front of the stroller, pull the
Shoulder Straps out completely. Rethread
each strap through the desired slots.
10
4. By reaching through the opening
backrest recline, find the end of the Harness
Straps and then feed them through the
harness slots in the backrest mechanism.
5. Connect the straps to the Splitter Plate.
There is only one set of strap holes in the
backrest mechanism.
6. Test that the harness works properly
by pushing down on the Harness
Release Button while pulling the
harness out through the new shoulder
position and then tighten by pulling
on the One-hand Adjustment Strap.

For Newborns

Use the lower Harness Positions (if they are
even with or just above your child's shoulders)
and the upper strap loops for the Splitter Plate.

For a Larger Baby

Use middle or upper Harness Positions and the
end strap loops for the Splitter Plate.
adjusting the Harness
for the
11