Automatic Front Wheels Swivel Locks; Extendable Canopy; Using The Harness System - CYBEX TWINYX User Manual

8. AUTOMATIC fRONT wHEEL SwIvEL LOCKS
a)
1) Push the Front Swivel Lock Lever until it "clicks".
It can be activated in any wheel position.The
swivel Lock will engage automatically once the
wheel swivels into the correct position.
2) Lift the Front Swivel Lock Lever up again to
release the Swivel Lock.

9. ExTENDAbLE CANOPY

a)
1) Attach both outer canopy clips onto the
inside of the outer frame tubes of the
buggy.
The middle canopy clip attaches from the
front onto the top middle frame tube of the
buggy.
To remove the canopy reverse procedure.
2) Extend the canopy and place canopy rear
flap behind the seat.
3) Lie-flat position: Put the rear flap over the
seat's back rest and fixate it with the two
velcros underneath.
32
a)
1
2

10. USING THE HARNESS SYSTEM

a)
1
b)
2
c)
3
4) The canopy is adjustable to various
positions.
The height can be easily adjusted by
simply sliding the canopy up or down on
the frame.
5) For maximum coverage, unzip the extra
panel on top of canopy and pull forward.
6) The canopy flap at the rear of the stroller
can be rolled up and fixed with a velcro
fastener, if required.
To close simply insert both buckle tongues into
the harness buckle.
To tighten the belts pull the strap on the front
of the central harness buckle until the harness
is snug.
To release the belt system press the release
button located on the seat in front of the belt lock
while pulling at the shoulder belts.
4/5
6
33