Installing Light Bulb; Adjusting The Table Square To Head; Bevel Scale - RIDGID DP1500 Owner's Manual

Installing Light Bulb

1. Install a light bulb (not larger than 60 watt) into the
socket inside the head.

Adjusting the Table Square To Head

NOTE: The combination square must be "true". See
"Unpacking and Checking Contents" section for method.
1. Insert precision round steel rod or straight drill bit
approximately 3" long into chuck and tighten.
2. With table raised to working height and locked on col-
umn, place combination square flat on table beside rod
or bit.
3. If an adjustment is necessary, loosen the set screw
under bevel lock with 3mm "L" wrench, then loosen the
table bevel lock bolt with the 24mm flat wrench
(included). (This adjustment is located under the
table).
4. Align the table square to the rotor bit by rotating table
until the square and rod or bit are in line.
5. Retighten table bevel lock.
6. Retighten set screw.

Bevel Scale

NOTE: The bevel scale has been included to provide a
quick method for beveling the table to approximate
angles. If precise accuracy is necessary, a square, or
other precision measuring tool should be used to position
the table.
1. To use the bevel scale do the following.
a. Loosen set screw and table bevel lock (see step 3
above).
b. Move table so desired angle on bevel scale is
straight across from zero line on table.
c. Retighten table bevel lock and set screw.
Set
Screw
Table Bevel
Lock
Pointer
Scale
15
Table
Table