Installing The Table; Installing The Head - RIDGID DP1500 Owner's Manual

Installing The Table

1. Loosen support lock and raise table support by turning
table crank clockwise until support is at a working
height level. Tighten support lock.
2. Remove protective covering from table and discard.
Loosen table lock, place table in table support and
tighten table lock (located under table) by hand.
NOTE: If table won't fit into table support easily, pry open
table support with a flat blade screwdriver.

Installing the Head

CAUTION: The head assembly weights about 61
pounds. To reduce the risk of back injury get help
to lift the head.
1. Locate (2) two 10mm dia. x 12mm long set screws in
loose parts bag.
2. Remove protective bag from head assembly and dis-
card. Carefully lift head above column tube and slide it
onto column making sure head slides down over col-
umn as far as possible. Align head with table and base.
3. Install a set screw in each hole (as indicated) on the
right side of the head, and using a 5mm hex "L"
wrench, tighten the two head lock set screws.
Support
Lock
Table
Support
Column
Table
Lock
10mm Dia. x 12mm
Set Screw
Head
11
Table
Crank
Rack
Table
Support
Table
Column
Head
Lock
Set
Screws
Head