Amana Front Loading Washers Installation And Operating Instructions Manual page 8

Installing Washer
NOTE: End of drain hose must be 24" to 36" above the
floor. Without 24" to 36" high elevation, water
may run out of washer prematurely.
B
C
A. Drain hose
B. Tie-down strap (tape if necessary)
C. Inlet hoses
In wall water hook up
Laundry Tub Installation
For this type of installation, the drain hose must be
secured to the stationary tub to prevent hose from
dislodging during use. Use the beaded tie-down strap
(supplied in accessories bag) to secure hose.
A
B
A. Drain hose
Laundry tub installation
A
B. Tie-down strap
4. Remove Shock Sleeves and Shipping
Brace
Remove 2 front access panel screws to remove
access panel. Save screws.
A
B
A. Front access panel
Access panel removal
Remove five bolts and five washers from yellow
marked shipping brace with a
remove brace. Remove label from outside access
panel and place on inside of access panel.
B
A
A. Shipping brace
Removing shipping brace
8
B. Access panel screws
9
/ " socket wrench and
16
B
B. Bolts and washers