Error Messages; Care And Maintenance - Jensen Phase Linear UV10 Instruction Manual

UV10
Problem
Disc does not play back
PBC cannot be used during VCD playback
No repeat or searching while playing VCD
MP3
Interruption occurred during playback
Incorrect playback message displayed

Error Messages

Message Displayed
Loading
No Disc
Bad Disc
Unknown disc
Region Error
Error

Care and Maintenance

1. Use only a clean silicone cloth and neutral detergent to
clean the front panel or monitor. A rough cloth and non-
neutral detergent (such as alcohol) may result in
scratching or discoloration.
2. Do not get water or cleaning fluids on the unit.
3. If the temperature inside the player gets too hot, a
protective circuit automatically stops play of the disc. If
this occurs, allow the unit to cool before operating the
player again.
Table 7: Troubleshooting
Cause
Disc is warped or scratched
Disc is dirty or wet
Laser pickup is dirty
Incompatible disc is used
Disc rating exceeds Parental Lock rating limit
Disc region code is not compatible with unit
Disc is inserted upside down
PCB is not available on the disc
PCB is on
Disc is dirty or scratched
File is damaged/bad recording
Message is longer than LCD can display
Table 8: Error Messages
Cause
Disc is being read
Disc is dirty
Disc is upside down
Disc not present in loading compartment
Disc is dirty
Disc is upside down
Disc format is not compatible with this unit
DVD is not compatible with region code of unit
Illegal mechanism operation
4. Never insert anything other than a 5" (12 cm) compact
disc into the player as the mechanism can be damaged
by foreign objects.
5. Do not attempt to use a 3" (8 cm) CD-Single disc in this
unit, either with or without an adaptor, as damage to the
player and/or disc may occur. Such damage is not
covered by the Warranty on this product.
6. The CD player may not operate properly in extreme hot
or cold. If such conditions occur, allow the interior of the
Corrective Action
Use disc in good condition
Clean disc with soft cloth
Clean laser pickup with cleaning disc
Use compatible disc
Change Parental Lock settings to lower restriction
Use disc with proper region code
Insert disc with label side up
Turn PCB off
Clean disc or replace
Recreate disc with good files
Corrective Action
Clean disc with soft cloth
Insert disc with label side up
Insert disc
Clean disc with soft cloth
Insert disc with label side up
Press EJECT key for 5 seconds to reset loading mechanism
7.
8.
25
vehicle to reach a normal temperature before using
player.
When the vehicle warms up during cold weather or
under damp conditions, condensation may appear on
the LCD panel. Should this occur, the screen will not
operate properly until the moisture has evaporated.
We suggest you use a cleaning disc in this unit more
frequently than in the unit in your home due to the
environmental conditions of the vehicle.