Basic Troubleshooting - Gogo ES 8 Owner's Manual

V I I I . B A S I C T R O U B L E S H O O T I N G
Any electromechanical device occasionally requires some troubleshooting. However, most of the problems that
may arise can usually be solved with a bit of thought and common sense. Many of these problems occur because
the batteries are not fully charged or because the batteries are worn down and can no longer hold a charge.
DIAGNOSTIC BEEP CODES
The diagnostic beep codes for your Travel Scooter are designed to help you perform basic troubleshooting
quickly and easily. A diagnostic beep code will sound in the event one of the conditions listed below
develops. A beep code will begin with a series of fast beeps directly followed by slower beeps which
indicates the actual code. The beep code is only beeped once. To repeat the beep code, remove the key,
then reinsert it and turn it to the "on" position.
NOTE: Your Travel Scooter will not run unless the beep code condition is resolved and the Travel
Scooter has been turned off, then turned back on.
BEEP CODE
(1)
(2)
(3)
(4)
(5)
What if all the systems on my Travel Scooter seem to be "dead"?
Make certain that the key is in the "on" position.
Check that the batteries are fully charged.
Push in the main circuit breaker reset button. See III. "Your Travel Scooter."
Make certain that the front-to-rear and battery harnesses are secured properly. See VIII. "Disassembly
and Assembly."
Be sure the power down timer feature has not been activated. See V. "Operation."
Check the fuse located on the underside of the tiller.
Go-Go ES8
CONDITION
Battery charge is low.
Battery charge is too low.
The Travel Scooter's battery voltage
is too high to operate the Travel
Scooter or the charger is still con-
nected to the off-board charger port.
Current limit time out.
The manual freewheel lever is in the
(forward) freewheel position.
Throttle control lever not at centre
(6)
position at start up.
Speed pot error.
(7)
(8) Motor volts error.
Other internal errors.
(9)
www.pridemobility.com
SOLUTION
Charge batteries as soon as possible.
Charge batteries.
Unplug charger and/or turn key off,
then back on again.
Turn the Travel Scooter off for a
few minutes, then turn your Travel
Scooter back on.
Remove the key from the key
switch, then push the manual
freewheel lever to
(rearward) position and restart your
Travel Scooter.
Return the throttle control lever to
centre position, turn Travel Scooter
off then back on.
Call your authorised Pride Dealer
for assistance.
Call your authorised Pride Dealer
for assistance.
Call your authorised Pride Dealer
for assistance.
the drive
35