Gogo ES 8 Owner's Manual page 28

I V . B A T T E R I E S A N D C H A R G I N G
5. Remove the old batteries.
6. Place the new batteries into the battery pack.
7. Connect the red battery cable to the positive (+) battery terminal of each battery.
8. Connect the black battery cable to the negative (-) battery terminal of each battery.
9. Completely zip the battery pack closed.
10. Reinstall the battery pack then connect the battery harnesses and battery tie-down strap.
11. Reinstall the rear shroud and seat.
NOTE: If you encounter a damaged or cracked battery, immediately enclose it in a plastic bag and
contact your local waste disposal agency or authorised Pride Dealer for instructions on disposal and
battery recycling which is our recommended course of action.
Why do my new batteries seem weak?
Deep-cycle batteries employ a different chemical technology than that used in car batteries, nickel-
cadmium batteries (nicads), and other common battery types. Deep-cycle batteries are specifically designed
to provide power, drain down their charge, and then accept a relatively quick recharge (8 to 14 hours).
We work closely with our battery manufacturer to provide batteries that best suit your Travel Scooter's
specific electrical demands. Fresh batteries are shipped fully charged to our customers. During shipping,
the batteries may encounter temperature extremes that can influence their initial performance. Heat
diminishes the charge on the battery; cold slows the available power and extends the time needed to
recharge the battery.
It may take a few days for the temperature of your Travel Scooter's batteries to stabilise and adjust to their
new room or ambient temperature. More importantly, it takes a few charging cycles (partial draining
followed by full recharging) to establish the critical chemical balance that is essential to a deep-cycle
battery's peak performance and long life.
Follow these steps to properly break in your Travel Scooter's new batteries for maximum efficiency
and service life:
1. Fully recharge any new battery prior to its initial use. This charging cycle brings the battery up to about
88% of its peak performance level.
2. Operate your new Travel Scooter in familiar and safe areas. Drive slowly at first and do not travel too
far from your home or familiar surroundings until you have become accustomed to your Travel
Scooter's controls and have properly broken in your Travel Scooter's batteries.
3. Fully recharge the batteries. They should be at over 90% of their peak performance level.
4. Operate your Travel Scooter again, then fully charge the batteries.
5. After four or five charging cycles, the batteries are able to receive a charge of 100% of their peak
performance level and are able to last for an extended period of time.
What about public transport?
If you intend to use public transportation with your Travel Scooter, you must contact the transportation
provider in advance to determine their specific requirements.
28
www.pridemobility.com Go-Go ES8