Gogo ES 8 Owner's Manual page 32

V I . C O M F O R T A D J U S T M E N T S
SEAT HEIGHT ADJUSTMENT
The seat can be repositioned to different heights.
See figure 19.
1. Remove the seat from your Travel Scooter.
2. Remove the rear shroud from your Travel
Scooter.
3. Disconnect the battery harnesses.
4. Disconnect the battery tie-down strap and
remove the battery pack.
5. Use the attached ring to pull and remove the
detent pin from the lower seat post.
6. Raise or lower the upper seat post to the desired
seat height.
7. While holding the upper seat post at that height,
align the adjustment holes of the upper and
lower seat posts.
8. Fully insert the detent pin.
9. Replace the battery pack and connect the
battery harnesses.
10. Fasten the battery tie-down strap.
11. Reinstall the rear shroud.
12. Reinstall the seat.
32
UPPER SEAT POST
LOWER SEAT POST
DETENT PIN
Figure 19. Seat Height Adjustment
www.pridemobility.com Go-Go ES8