Table of Contents
Advertisement
Section 2 - Installation
4. Plug one end of the included blue Ethernet cable that came with your router into the yellow port labeled
INTERNET on the back of the router. Plug the other end of this cable into the Ethernet port on your modem.
5. Reconnect the power adapter to your cable or DSL broadband modem and wait for two minutes.
6. Connect the supplied power adapter into the power port on the back of the router and then plug it into a power
outlet or surge protector. Press the power button and verify that the power LED is lit. Allow 1 minute for the
router to boot up.
7. If you are connecting to a Broadband service that uses a dynamic connection (not PPPoE), you may be online
already. Try opening a web browser and enter a web site. If you connect, you are finished with your Internet setup.
Please skip to page 14 to configure your router and use the manual setup procedure to configure your network
and wireless settings. If you did not connect to the Internet, use the D-Link Setup Wizard (refer to page 15).
D-Link DIR-815 User Manual
DIR-815
4
3
2
1
INTERNET
POWER
12V
1A
RESET
DIR-815
4
3
2
1
INTERNET
POWER
12V
1A
RESET
Modem
11
Advertisement
Table of Contents
