How To Use The Vise Assembly - Hitachi C 10FSB Technical Data And Service Manual

CAUTION:
Laser radiation - Do not stare into beam.
Laser radiation on work table. Do not stare into beam.
If your eye is exposed directly to the laser beam, it can be hurt.
Do not dismantle it.
Do not give strong impact to the laser marker (main body of tool); otherwise, the position of a laser line can go
out of order, resulting in the damage of the laser marker as well as a shortened service life.
Keep the laser marker lit only during a cutting operation. Prolonged lighting of the laser marker can result in a
shortened service life.
NOTE:
Perform cutting by overlapping the ink line with the laser line. When the ink line and the laser line are
overlapped, the strength and weakness of light will change, resulting in a stable cutting operation because you
can easily discern the conformity of lines. This ensures the minimum cutting errors.
In outdoor or near-the-window operations, it may become difficult to observe the laser line due to the sunlight.
Under such circumstances, move to a place that is not directly under the sunlight and engage in the operation.
Do not tug on the cord behind the motor head or hook your finger, wood and the like around it; otherwise, the
cord may come off and the laser marker may not be lit up.
Instruct the above precautions on the laser marker to the customers.

8-5. How to Use the Vise Assembly

(1) The vise assembly can be mounted on either the left or
right fence. To mount the vise assembly on the left fence,
align the upper surface of the fence with the V-groove on
the vise shaft or the upper surface of the stage. Then the
tip of the 6-mm wing bolt properly fits in the groove on the
vise shaft. To mount the vise assembly on the right
fence, align the tip of the 6-mm wing bolt at the rear of the
fence with the vise shaft groove that is 1 or 2 stages
lower than the above. Thus the height of the vise shaft
can be adjusted in three stages. On completion of
adjustment, tighten the 6-mm wing bolt to secure the vise
shaft (Fig. 34).
(2) Adjust the position of the screw holder and lock it in
position by tightening the 6-mm knob bolt.
(3) Turn the knob to clamp the workpiece securely.
[CAUTION] (1) Ensure without fail the saw blade section does not come in contact with the vise assembly
when the motor head is pushed down. In the case of bevel cutting, mount the vise
assembly to the fence on the opposite side from which the saw blade is tilted to avoid
contact with the saw blade section.
(2) In the case of compound cutting, mount the vise assembly to the right fence.
6-mm knob bolt
V-groove
Groove
Fence
6-mm wing bolt
--- 23 ---
Screw holder
Knob
Vise plate
Fig. 34