RIKA INTEGRA II Manual page 15

INSTALLATION
Additional Venting Instructions
Caution: Optimum safety, combustion
and burn quality cannot be achieved if
these guidelines are not followed.
Failure to follow these guidelines will
void your warranty.
Caution: All chimney connectors must
be kept clean and in good condition.
Caution: Do
methods or
installation.
• Only use ventilation components
designed and approved for use with
a pellet stove.
• Although
straight out horizontal venting is
acceptable, however if a vertical
termination is employed, minimum
vertical rise (to termination point)
must be no less than the total height
of the stove.
• Each 90° angle or T-connector adds
an effect of five additional feet of
pipe length. Each
an effect of three additional feet of
pipe length.
• 4"
venting
installations at or above elevations
of 2500 feet.
• 4"
venting
installations where the total length of
venting is equal to or greater than
20 feet including the effective length
of any angles.
Copyright © 2008 by Lucky Distributing
not use make-shift
compromises in
not recommended,
45° angle adds
is required in
is required in
• The maximum length of any venting
configuration should not exceed 30
feet total, including the effective
lengths of any angles.
• No portion of the ventilation system
shall pass through an attic or roof
space, closet or similar concealed
space, or a floor or ceiling.
• Follow all manufacturers' ventilation
installation instructions.
the
all
all
15