General Information For Cd Operation; Inserting And Removing The Memory Card; External Sources - Skoda AMUNDSEN+ Owner's Manual

12 MEDIA mode

General information for CD operation

Insert CD
– Insert a CD with the written side facing up as far as possible into the CD case
until it is automatically drawn in. The play function will start automatically.
Eject CD
A
– Press the button , the CD is ejected.
 11
If the CD is not taken out within 10 seconds, it will be retracted again for safety
reasons.
CD not legible
If you insert a CD which cannot be read by the unit, a pop-up window is displayed
with a note. Press on the function key
WARNING
The CD player is a 1st class laser product. There is a definite risk of injury from
invisible laser beams if it is opened.
Caution
•
Only audio-CDs (CD-A) and MP3-CDs can be played in the internal drive. Never
place DVDs into the internal drive- irreparable damage may result.
•
Never place Eco Disc CDs into the internal drive.
•
Inserting a second CD while a CD is being ejected can destroy the CD drive in the
unit. After pressing the Eject button
CD is ejected. During this time the lock in front of the CD case is open. It is essential
that you wait until the CD has been fully ejected before you try to insert a new CD.
•
If the CD has mechanical damage or is incorrectly or not fully inserted, the
following message " appears in the display: CD". Please check the CD and place it
again correctly into the drive. if the message "Error: CD" appears again, try a
different CD. you may need to contact a specialist garage.
•
If the inside temperature of the unit is too high, no CDs will be accepted. The unit
switches into the last active operating mode.
Note
•
If the function key is inactive, no Audio CD has been inserted or the inserted
CD
Audio CD is not readable.
, the CD is driven to the initial position.
OK
there is a delay of a few seconds before the

•
It is possible that CDs protected by copyright and self-made CD-R and CD-RW
are not returned at all or only in certain circumstances.
•
Please comply with the national legal copyright requirements in your country.
•
The CD player contains no parts that have to be serviced or repaired. If the CD
A
9
player is defective, contact a specialist garage.

Inserting and removing the memory card

Inserting a memory card
– Push the memory card into the memory card case
the front right until it "locks into place". The play function will start automati-
cally.
Taking out a memory card
– In the "System and sound settings" menu, choose the menu point "Remove SD
card"  page 8, "System and sound settings".
– Press the inserted memory card. The memory card "jumps" into the initial posi-
tion.
Memory card empty or data not readable
If a memory card is inserted, on which no data or no legible data has been stored, it
will not be switched over into the memory card mode after the loading procedure.

External sources

External sources - Overview
Input AUX
Press the button and then the function key
MEDIA
The input for an external audio source AUX is located on the front of the unit
External audio sources connected to the AUX socket cannot be operated via the
radio navigation system.
Use the standard jack plug 3.5 mm for the AUX socket. If the external audio source
does not have this jack plug, you must use an adapter  page 14, "Requirements for
media sources and audio files".
A with the trimmed edge to
16
.
AUX
A
.
14