(2) Diassembly and reassembly of the magazine section (See Fig. 20.)
Body
Nylon Nut
Ass'y [31]
M4 [69]
Cover Plate
Nail Rail [90]
Ribbon Spring [79]
Nail Feeder
[94]
(a) Disassembly
Remove the Hex. Socket Hd. Bolt (W/Sp. Washer) M5 x 12 [82] with the hex. bar wrench M5.
Remove the Nylock Hex. Socket Flat Hd. Bolt M4 x 6 [95] and the two Nylock Hex. Socket Flat Hd. Bolts
M4 x 10 [96] with the hex. bar wrench M3. Then the Nail Feeder [94], Magazine Cover [71] and Cover Plate
[70] can be removed. Ensure that the nail feeder is not pulled during the above operation.
Remove the retaining ring for D3 shaft with the blade of a screwdriver. Then the ribbon spring can be
removed.
Pull out the Roll pin D2.5 x 12 [98] with the roll pin puller (3 mm (.118") dia.) and remove the Hex. Socket Hd.
Bolt M4 x 16 [100] with the hex. bar wrench M4. Then the Magazine Protector [99], Sleeve [88] and nail rail
can be removed.
Remove the Hex. Socket Hd. Bolt (W/Sp. Washer) M4 x 14 [101] with the hex. bar wrench. Then Magazine
(A) [81], Magazine (B) [92] and Spacer [93] can be removed.
(b) Reassembly
Disassembly procedures should be followed in the reverse order. Note the following points.
Magazine Cover [71]
[70]
Nylock
Hex. Socket Flat
Hd. Bolt M4 x 10 [96]
Nail Rail [90]
Pin [78]
Hex. Socket Hd. Bolt
(W/Sp. Washer)
M5 x 12 [82]
Fig. 20 Disassembly and reassembly of the magazine section
Nylon Nut M4
[69]
Sleeve
[88]
Magazine (A) [81]
Retaining Ring (E-type)
for D3 Shaft [83]
--- 27 ---
Nylon Nut M4 [69]
Magazine (B) [92]
Spacer [93]
Nylock Hex. Socket
Flat Hd. Bolt M4 x 6
[95]
Magazine
Protector
[99]
Roll Pin
D2.5 x 12 [98]
Hex. Socket Hd.
Bolt M4 x 16 [100]
Hex. Socket Hd. Bolt
(W/Sp. Washer) M4 x 14 [101]