Table of Contents
Advertisement
Conversion To LP Gas
Control Settings
This appliance is shipped from the factory equipped for
The size and type of cookwareand the amountand type
use with Natural Gas. To convertit from NaturalGas for
of foodbeing cookedwill influencethe settingneededfor
use with LP Gas, performsteps 1 through4.
bestcookingresults.The settingindicatedshouldserve as
1. Remove Natural Gas orificehoods.Installcolor coded
a guidewhile you become familiarwith your cooktop.
orificehoodssupplied.Located in a packattachedto
the outer plenumarea of this appliance,
Use the HI flame settingto
quicklybringfoodsto a boilor to
(See Illustration "E", below,and LP Gas Conversion
begina cookingoperation.Then
instructions page 8).
reduce to a lower settingto
2. _nvertcap in convertiblepressureregulator(if so
continuecooking.Never lease
equipped)locatedat entranceto gas manifold,
foodunattendedover a HI flame
3. Adjustair shutterson individualburnersfor proper
setting.
flame appearance.
Med settingis used to continuea
4. Adjustlow flame settingat each burnerby turning
cookingoperation.Food will not
adjustmentscrew in center ofvalve stem.
cook any fasterwhen a HI flame
To make these conversionsadjustments followthe
settingis used than that needed
instructions and illustrations ("A" through"E", pages
to maintaina gentleboil.
5-7).
Remember,water boilsat the
same temperaturewhether boiling
gentlyor vigorously.
Apply a non-corrosiveleak detectionfluid to all joints
Use LO settingto keep food at
and fittingsin the gas connectionbetweenthe supply
servingtemperatureswithout
lineshut-offvalve and the range. Includegas fitting
further cookingYou may find that
and jointsin the range if connections were disturbed
some cookingmay take place if
during installation. C heck for leaks! Bubblesappearing
the cookwareis covered.
aroundfittingsand connections willindicatea leak, If a
leak appears,turn off supplylinegas shut-offvalve,
tightenconnections,turn on the supplyline gas shut
off valve, and retestfor leaks. Never test for gas leaks
with an openflame.
This appliance is shipped from the factory with orifice
hoods drilled for use with Natural Gas. To convert from
Natural Gas to LP, apply a 112"open-end wrench to hex
section of orifice hood. Turn counterclockwise to remove.
Save the Natural Gas orifice hoods just removed from this
appliance for future use. Install color coded orificehoods
supplied. (See LP Gas Conversion instructions above and
page 8). Turn clockwise to install. Hold dimension
specified in illustration "E".
1/2" OPEN END
_
J
WRENCH
_
TURN
CLOCKWISE
•
TO TIGHTEN
TURN
1
COUNTERCLOCKWISE
TO REMOVE
ORIFICE HOOD
Illustration "E"
Advertisement
Table of Contents
