Setting Cruise Control; Resuming A Set Speed - Cadillac 2010 STS Owner's Manual

Ofrecido por www.electromanuales.com
T (Set/Decrease) : Press to set the speed or to
decrease the speed when cruise is already active.
(Cancel): Press this button on the steering wheel to
cancel cruise control without erasing the set speed from
memory.

Setting Cruise Control

{
WARNING:
If you leave your cruise control on when you are
not using cruise, you might hit a button and go
into cruise when you do not want to. You could be
startled and even lose control. Keep the cruise
control switch off until you want to use cruise
control.
1. Move the cruise control switch to on.
2. Get up to the speed desired.
T
3. Press at the end of the lever and release it.
4. Take your foot off the accelerator pedal.

Resuming a Set Speed

If the cruise control is at the set speed desired and then
the brake is applied, the cruise control is disengaged.
But it does not need to be reset.
Once the vehicle speed reaches about 40 km/h
(25 mph) or more, move the cruise control switch briefly
R S
from to .
The vehicle will go back up to your chosen speed and
stay there.
If the switch is held at resume/accelerate the vehicle
keeps going faster until the switch is released or the
brake is applied. Do not hold the switch at resume/
accelerate, unless you want the vehicle to go faster.
This light on the
instrument panel cluster
comes on while cruise
control is on.
4-13