IBM TotalStorage NAS 300 User Reference page 124

10. You will be asked to select the language that you want to use. Select your
11. Shut down (see "Shutting down and powering on the NAS Gateway 300" on
12. Remove the jumper on the boot-block jumper block, or move it to pins 1 and 2
13. Restart the NAS Gateway 300. The NAS Gateway 300 should start up
110
NAS Gateway 300 User's Reference
6. Restart the NAS Gateway 300.
7. After the NAS Gateway 300 completes the POST, select 1 -- Update
POST/BIOS from the menu that contains various flash (update) options.
8. When you are asked if you would like to move the current POST/BIOS image
to the backup ROM location, type N.
Attention: Typing Y will copy the corrupted BIOS into the secondary page.
9. When you are asked if you would like to save the current code on a diskette,
select N.
language (0 - 7) and press Enter to accept your choice. You will be prompted
to remove the diskette and press Enter to restart the system. Remove the
flash diskette from the diskette drive.
page 87) the NAS Gateway 300.
to return to normal startup mode.
normally.