Table of Contents
Advertisement
Other
Hints
on Caring
for
Your Oven
Cleaning
Other
Surfaces
of Your
Oven
Door and control
panel trim: The metal trim around the door and the control panel
can be cleaned with any nonabrasive cleansers such as Ben Ami or soapy water, rinse
well. Be careful not to use an excessive amount of water.
Glass on the oven door front:
To clean, use any suitable glass cleaner or soapy
water. To prevent moisture from getting behind the glass control panel,spray a cloth with
glass cleaner then wipe the panel.
Control Knob: Control knob can be removed for cleaning. Wash in warm soapy water.
Match the "D" shaped hole in the knob to the "D" shaft when replacing.
Control Panel: Wipe with a damp cloth. Dry thoroughly. Do not use cleaning sprays,
large amounts of soap and water, abrasives, or sharp objects on the panel-they can
damage it.
Oven
Racks
__'
_
To remove pull forward to the"stop" position; lift
___)j_t_/_f
up on the front of the rack and pull out.
_
\ _/1_
I I\ [_1
" .......
Oven
Light
Bulb
Before replacing bulb, disconnect powerto oven at the main fuse or circuit breakerpanel.
Be sure that the entire oven cavity including the light bulb is cool before attempting to
remove.
To replace
light bulb:
1.
Carefully remove the glass light lens and lens retainer by
removing the two screws in the light lens retainer using a
phillips screwdriver. Note: The light lens is separate from the
light lens retainer. The two pieces will drop down into your
hands at the same time. Do NOT remove the remaining two
screws.
2.
To obtain firm graspon bulb, wear protectiverubbergloves.
Removebyturningbulbtothe left. Donot touch a hotoven light
bulb with a damp cloth as bulb will break. NOTE: If the bulb
does break and youwishto removeit,be certainpowersupply
is disconnected and wear protective gloves. You may contact
your authorizedJenn-Air ServiceContractorfor service.
3.
Replace bulb with a 40 watt oven-rated appliance bu/b. Bulb
withbrass baseis recommendedtopreventfusingof bulbinto
socket.
4.
Place light lens inside of light lens retainer. Holding the light
lens and lens retainer in place, insert the two screws into the
light lens retainer and tighten.
33
Hide quick links:
Advertisement
Table of Contents
