Table of Contents
Advertisement
· Remove the paper feed guide from the
auto cutter assembly.
(1) Pull out the paper feed guide in
an arrow-indicated direction.
· Remove the mouth plate from the
auto cutter assembly.
(1) Using a Phillips screwdriver,
remove 4 screws (M2 x 3) from
the mouth plates R and F2.
(Note) There are bosses on the cutter
side.
when tightening the screws at
assembly.
6. Remove a roller holder.
(1) Using
the
remove screws(binder, M2.6 x 6).
(2) Remove the roller holder from the
case.
· Remove a roller from the roller holder.
(1) Expose
section of the roller holder to the
outside to remove a roller.
Pay attention to them
Phillips
screwdriver,
the
roller
receiving
- 10 -
CBM-292/293 Service Manual
CITIZEN
Advertisement
Table of Contents
