Program Diagram - Haier HT-3718 Service Manual

9.

Program Diagram

Insert the power plug into the power line socket and insert the antenna plug into the antenna
socket on the rear panel. Press down the power switch of the TV set. The red indicator light goes
on. If no picture appears, press the button
A Program preset
1. Auto searching and storing program
Press MENU button on the remote controller then use the "CH+/CH-" key to call up the "tune
program" menu on the screen. Then Press the menu" VOL+/VOL- " item to adjust. it.Use the
"CH+/CH- " key to select the bar "auto search program" then press the "VOL+/VOL-" to make
sure. If you want to stop ,press the key " MENU ".
2. Manual search and fine tune
Press MENU button then use the "CH+/CH-" key to call up the "tune program" menu on the
screen. Then Press the menu" VOL+/VOL- " item to adjust. it.Use the "CH+/CH-" key to select
the bar "Manual search program" then press the "VOL+/VOL-" to make sure.
3.Deleting channel number
Press Program up/down buttons to select a channel to skip. Press MENU to call Menu. then
use the "CH+/CH- " key to call up the "tune program" menu on the screen. Then Press the
menu" VOL+/VOL- " item to adjust. it.Use the
number" then press the "VOL+/VOL-" to make sure. Enter the number that you do not want to
see .Then Then select "SKIP" and select SKIP to ON. Now the program number is deleted.
Repeat the above steps and select SKIP to OFF, the deleted program number can be resumed.
B Volume tuning
Press VOLUME buttons VOL+ to increase and VOL- to decrease the volume.
C Personal preference settings
Picture modes
Press SELC PICTURE repeatedly to change among MEMORY 1, MEMORY2,MEMORY3,to chang
the Picture Mode.
on the remote controller. Follow the steps below.
"CH+/CH-" key to select the bar "Cannal
14
Program Diagram