9.Program Diagram
Insert the power plug into the power line socket and insert the antenna plug into the antenna socket
on the rear panel. Press down the power switch of the TV set. The red indicator light goes on. If no
picture appears, press the button
A Program preset
1)
Auto searching and storing program
Press MENU button on the remote controller then use the "
program" menu on the screen. Then Press the menu"
to select the bar "auto search program" then press the "
stop ,press the key "
2)
Manual search and fine tune
Press MENU button then use the "
Then Press the menu"
program" then press the "
3) Deleting channel number
Press Program up/down buttons to select a channel to skip. Press MENU to call Menu. then
use the "
" key to call up the "tune program" menu on the screen. Then Press the menu"
" item to select it.Use the "
make sure. Enter the number that you do not want to see .Then Then select "SKIP" and select
SKIP to ON. Now the program number is deleted. Repeat the above steps and select SKIP to
OFF, the deleted program number can be resumed.
B Volume tuning
Press VOLUME buttons
C Personal preference settings
Picture modes
Press SELC PICTURE repeatedly to change among MEMORY 1, MEMORY2,MEMORY3,to chang
the Picture Mode.
on the remote controller. Follow the steps below.
".
" key to call up the "tune program" menu on the screen.
" item to select it.Use the "
" to make sure.
" key to select the bar "Cannal number" then press the "
- to increase and
" item to select it.Use the "
" to make sure. If you want to
" key to select the bar "Manual search
+ to decrease the volume.
14
Program Diagram
" key to call up the "tune
" key
" to