Table of Contents
Advertisement
(2) User simulation prcedure
Simulation procedure
1. Press the paper feed section select
key for more than 5 sec.
2. Enter a code number with 10 key.
3. Press the COPY button.
4. Enter the selection code with 10 key.
5. Press the COPY button.
6. Press the paper feed section select
key.
* Press the clear key.
(3) User program code table
[ES conforming area]
P
Program
code
Auto clear passing
1
time setting
Preheat mode
2
setting and passing
time setting
Auto off mode
3
passing time setting
Stream feeding
mode setting and
4
cancel (Only
models with SPF)
Auto power shut off
5
mode setting, cancel
@
When auto power shut off mode passing time setting (operation
with P code [3]) is made under the state where the auto power
shut off mode is canceled ("[0]: NO" is selected with P code [5]),
the machine enters the auto power shut off mode set conditions
without operation with program [5].
User simulation input allowed.
Simulation code selection.
Simulation code determined.
Simulation code menu selection.
Simulation code menu determined.
Escape from user simulation.
•
When this key is pressed during user
simulation selection, the mode returns to
state 1 (user simulation input allowed.)
(Use this key to correct mistyping of input.)
•
After completion of program setting, when
this key is pressed, the mode the following
program input can be made.
Selection code:
Factory setting
Set content
0: NO
1: 30 sec.
2: 60 sec.
2: 60 sec.
3: 90 sec.
4: 120 sec.
0: NO
1: 30 sec.
2: 60 sec.
0: NO
3: 90 sec.
4: 120 sec.
0: NO
Since P code
1: 30 min.
[5] is set to "[0]:
2: 60 min.
NO,"
3: 90 min.
setting is set to
4: 120 min.
[0] though there
5: 240 min.
is no selection
code specified.
0: NO
0: NO
1: YES
0: NO
0: NO
1: YES
State
replacement/
toner supply
warning LED
this
8 – 13
Paper jam/
developer
Copy quantity
display
Blink
1
Blink
1
1
Blink
1
2
Blink
1
2
Blink
Returns to
OFF
copy quantity
display.
Blink
(
Print LED
OFF
ON
ON
ON
OFF
—
OFF
: Blink)
Advertisement
Chapters
Table of Contents
