(2) Adjustment of clearance between DV doctor
and MG roller
If the clearance between the DV doctor and the MG roller is improper,
the following troubles may occur:
•
Insufficient copy density
•
Copy dirt
•
Toner splash
1
Remove the DV cover.
2
Loosen the DV doctor fixing screw.
3
Insert a 0.625mm thickness gauge into the clearance between the
MG roller and the DV doctor in the range of 30mm width under the
DV doctor fixing screw.
A
30mm
30mm
4
Press the DV doctor in the arrow direction and tighten the DV
doctor fixing screw.
Check that the clearance of the DV doctor is 0.625 ±0.03mm in
5
the range of 30mm width under the DV doctor fixing screw.
Note: When adjusting, be careful not to scratch the DV doctor.
A
7 – 2
0.625±0.03mm
MG