HOW TO INITIALIZE THE PLASMA DISPLAY
To put the program back at the factory-default,
initialize the Plasma Display as the following
procedure.
1. To turn the power on, press "POWER" button on
the normal remote control unit or the unit.
2. Use the service remote control unit.
3. To enter the service mode, press "SLEEP" button
on the service remote control unit.
4. To reset to factory setting, press "DISPLAY" button
on the normal remote control unit.
- "INITIALIZE" (red) appears on the screen as
shown in Fig. 1.
MAIN UCOM Ver.
: K798-016
MEMORY SIZE
: 4
CHKSUM
: Push 0 key
- After few seconds (completion initialization), col-
or of "INITIALIZE" will change green.
INITIALIZE
Fig. 1
1-7-1
L0653INT