Applicable Controls - Toshiba MMU-AP0092H Installation Manual

SMMS 4-way Air Discharge Cassette Type
8

APPLICABLE CONTROLS

REQUIREMENT
• When you use this air conditioner for the first
time, it takes approx. 5 minutes until the
remote controller becomes available after
power-on. This is normal.
<When power is turned on for the first time
after installation>
It takes approx. 5 minutes until the remote
controller becomes available.
Power
SETTING
on flashes
<When power is turned on for the second
(or later) time>
It takes approx. 1 minute until the remote
controller becomes available.
Power
SETTING
on flashes
• Normal settings were made when the indoor
unit was shipped from factory.
Change the indoor unit settings as required.
• Use the wired remote controller to change the
settings.
* The settings cannot be changed using the
wireless remote controller, sub remote
controller, or remote-controllerless system
(for central remote controller only).
Therefore, install the wired remote controller
to change the settings.
Approx. 5 minutes
Remote
SETTING
goes out controller
is available
Approx. 1 minutes
Remote
SETTING
goes out controller
is available
– 22 –
Changing of settings of for
applicable controls
Basic procedure for changing settings
Change the settings while the air conditioner is not
working.
(Be sure to stop the air conditioner before making
settings.)
The display content for setting differs from that on
the former types of remote controller (RBC-
AMT21E/AMT31E). (The number of CODE No.
has increased.)
4
6
1 5
1
Procedure
Push button and "TEMP."
simultaneously for at least 4 seconds.
After a while, the display flashes as shown in the
figure.
Confirm that the CODE No. is [10].
• If the CODE No. is not [10], push
erase the display content, and repeat the
procedure from the beginning.
(No operation of the remote controller is
accepted for a while after
(While air conditioners are operated under the
group control, "ALL" is displayed first. When
is pushed, the indoor unit number
displayed following "ALL" is the header unit.)
(* Display content varies with
the indoor unit model.)
Installation Manual
1
3
EN
2
button
button to
button is pushed.)
22-EN