Validating Your Configuration - Motorola NVG510 Administrator's Handbook

Administrator's Handbook
option (off) [on | off]:
You can accept the default value for a field by pressing the Return key. To use a different value, enter it and press
Return.
You can enter the CONFIG step mode by entering
step mode for a particular service by entering
<Return/Enter> to exit. For example:
Motorola-3000/9437188 (top)>> set system
...
system
name ("Motorola-3000/9437188"): Mycroft
Diagnostic Level (High): medium
Stepping mode ended.

Validating Your Configuration

validate
You can use the CONFIG command to make sure that your configuration settings have been
validate
entered correctly. If you use the
for all services are present and that settings are consistent.
Motorola-3000/9437188 (top)>> validate
Error: Subnet mask is incorrect
Global Validation did not pass inspection!
validate
You can use the command to verify your configuration settings at any time. Your Motorola Gateway
automatically validates your configuration any time you save a modified configuration.
94
on
set
from the top node of the CONFIG hierarchy. You can enter
.
set
service_name In stepping set mode (press Control-X
command, the Motorola Gateway verifies that all required settings