Wan Commands - Motorola NVG510 Administrator's Handbook

Administrator's Handbook
view config
Dumps the Motorola Gateway's configuration just as the
who
Displays the names of the current shell and PPP users.

WAN Commands

atmping vccn [ segment | end-to-end ]
Lets you check the ATM connection reachability and network connectivity. This command sends five Operations,
Administration, and Maintenance (OAM) loopback calls to the specified vpi/vci destination. There is a five second
total timeout interval.
Use the segment argument to ping a neighbor switch.
Use the end-to-end argument to ping a remote end node.
reset dhcp client release [ vcc-id ]
Releases the DHCP lease the Motorola Gateway is currently using to acquire the IP settings for the specified DSL
vcc-id
port. The identifier is an "index" letter in the range B-I, and does not directly map to the VCC in use.
reset dhcp client release
Enter the
each virtual circuit.
reset dhcp client renew [ vcc-id ]
Renews the DHCP lease the Motorola Gateway is currently using to acquire the IP settings for the specified DSL
vcc-id
port. The identifier is an "index" letter in the range B-I, and does not directly map to the VCC in use.
reset dhcp client release
Enter the
circuit.
reset dsl
Resets any open DSL connection.
reset ppp vccn
Resets the point-to-point connection over the specified virtual circuit. This command only applies to virtual circuits
that use PPP framing.
show atm [all]
Displays ATM statistics for the Motorola Gateway. The optional all argument displays a more detailed set of ATM
statistics.
show dsl [ all ]
Displays DSL port statistics, such as upstream and downstream connection rates and noise levels.
90
view
command does in config mode.
command without the variable to see the letter assigned to
without the variable to see the letter assigned to each virtual