Error Codes - Mitsubishi Electric WD-52525 Service Manual

MODEL: WD-52525 / WD-52725 / WD-52825 / WD-62525 / WD-62725 / WD-62825
3. Error Code Operational Check
Note: The TV must be in "Shut Down" and not manually switched Off, to perform the Error Code Opera-
tional Check. When the TV is switched Off, the code automatically resets to "12" No Error.
Press the front panel "DEVICE" and "MENU" buttons at the same time, and hold for 5 seconds to
activate the Error Code Operational Check. The LED will then flash denoting a two digit Code.
Note: The front panel buttons must be used, NOT those on the Remote Control.
The number of flashes indicates the value of the MSD (tens digit) of the Error Code.
•
The flashing then pauses for approximately 1/2 second.
•
The LED then flashes indicating the value of the LSD (ones digit) of the Error Code.
•
Example: If the Error Code is "32", the LED will flash three times, pause, and then flash two times.
The Error Code is repeated a total of 5 times.
•

4. Error Codes

The Error Code designations are listed below:
Press and Hold "DEVICE" and "MENU" FOR 5 SECONDS
Error Code
12
22
32
33
34
35
36
37
38
39
41
44
ERROR CODES
Proba ble Ca use
No error detected
Recovery from momentary Reset
Lamp Cover open
Air Filter Cover open
Lamp abnormality
Chassis Fan failure
Exhaust (Back Cover) or Lamp Ballast Fan failure
Engine (DMD or Lamp) Fan failure
Excess Lamp Temperature
Excess DMD Temperature
Short Detected
DVI Cable (between Chassis and Engine) disconnected
Page 23