Device Installation; Power On Router; Factory Reset Button - D-Link DSL-2760U User Manual

Wireless n adsl2+ modem router

Table of Contents

D-Link DSL-2760U USER'S MANUAL

The DSL-2760U connects two separate physical interfaces, an ADSL (WAN) and an Ethernet (LAN) interface. Place the Router in a location where it can be

connected to the various devices as well as to a power source. The Router should not be located where it will be exposed to moisture or excessive heat. Make

sure the cables and power cord are placed safely out of the way so they do not create a tripping hazard. As with any electrical appliance, observe common sense

safety procedures.

The Router can be placed on a shelf or desktop, ideally you should be able to see the LED indicators on the front if you need to view them for troubleshooting.

The Router must be used with the power adapter included with the device.

Insert the AC Power Adapter cord into the power receptacle located on the rear panel of the Router and plug the adapter into a suitable nearby power

source.

Depress the Power button into the on position. You should see the Power LED indicator light up and remain lit.

If the Ethernet port is connected to a working device, check the Ethernet Link/Act LED indicators to make sure the connection is valid. The Router will

attempt to establish the ADSL connection, if the ADSL line is connected and the Router is properly configured this should light up after several seconds. If

this is the first time installing the device, some settings may need to be changed before the Router can establish a connection.

The Router may be reset to the original factory default settings by using a ballpoint or paperclip to gently push down the reset button in the following sequence:

Ensure the Router is powered on.

Press and hold the reset button on the back of the device for approximately 6 to 10 seconds.

This process should take around 1 to 2 minutes.

Remember that this will wipe out any settings stored in flash memory including user account information and LAN IP settings. The device settings will be restored

to the factory default IP address 192.168.1.1 and the subnet mask is 255.255.255.0, the default management Username is "admin" and the default Password is

"admin."