Getting Started - OneRemote RMB4 User Manual

Getting Started

With the OneRemote converter installed in your Bang & Olufsen Beo4 remote control terminal you may
control your Samsung TV with that terminal. This guide explains how.
Basically there are two models of the Beo4. The OneRemote control of your TV depends on which Beo4 model
is used and in which mode it is operated.
If the OneRemote converter has not yet been optimized for your setup, you might want to refer to the
installation section below for the initial setup and option programming. No programming is needed during
everyday use.
The OneRemote converter installed in your Beo4 remote control may be used in any Beo4 generation, in the
Beo4 Navi with extra functionality.
To get the most of your modified Beo4 the OneRemote converter must be programmed according to the Beo4
model and the equipment setup that your TV is a part of. Refer to page 5 and onwards for the initial
programming.
www.oneremote.dk
Previous Beo4 model 16xx. Sold until 2010.
The center key Oequals p in earlier B&O remotes.
If your OneRemote modified Beo4 is of this type:
Refer to the control table on page 5 for
how to control your Samsung TV with this Beo4.
Beo4 Navi model 17xx. Sold from 2010.
The center key is changed to a joystick that can be pushed
forward, backwards and to the sides. This adds new control
possibilities.
Mode 1 &3
To utilize these possibilities the Beo4 must be set in mode 1 or
3. Refer to the original Beo4 user manual for mode setting.
Refer to the control table on page 6 for how to control your
Samsung TV with this Beo4 in mode 1 or 3.
Mode 2
When the Beo4 Navi is in its default mode 2, it operates as
previous models 16xx.
Refer to the control table on page 5 for
how to control your Samsung TV with this Beo4 in mode 2.
Page 2