Swann SwannEye User Manual page 24

6. FPS: The number of Frames Per Second the interface will display. "Full Speed"
will display the maximum number of frames supported by the camera and
your network connection. Typically, this will be Realtime. Lowering the
frame rate can improve performance if you're on a slow network/Internet
connection.
Resolution: Set the viewing resolution to 640x480 (VGA), 320x240 (QVGA)
7.
or 160 x 120 (QQVGA).
Mode: Select between 50Hz, 60Hz or Outdoor mode, depending on your
8.
region and environment. 60Hz is the usual setting for North America. If you
find that the image flickers in indoor environments when under fluorescent
lights, you probably have this on the wrong setting.
Brightness: Adjusts the brightness. Use the + or - buttons to raise or lower
9.
the value in the range 0-15.
10. Contrast: Adjusts the brightness. Use the + or - buttons to raise or lower the
value in the range 0-15.
11. Default All: Resets all the settings in this Operator section back to their
default values.
12. Alarm I/O ON/OFF: The top button enables the Alarm I/O panel, and the
button underneath disables it. See "8.4.11. Alarm: Alarm Settings" on page
35 for more information.
24
SwannEye IP Camera