Cleaning Of Air Filter; Adjusting The Clutch Cable; Adjusting The Throttle Cable - KTM 60 SX Owner's Manual

2
2
3
A
5
4
3-5 mm

Cleaning of air filter*

1
To do this, remove the seat and the air filter cover from the air filter box.
Unclap the filter holder
3
rier
D
O NOT CLEAN FOAM FILTER WITH FUEL OR PETROLEUM SINCE THESE DAMAGE THE
. KTM
FOAM
TER MAINTENANCE
F "
LUID
Thoroughly wash the foam filter in special cleaning fluid and allow to dry
well. Only press out the filter, do not wring out under any circumstances.
Oil the dry foam filter with a high grade filter oil. Also clean the air filter box.
Check carburettor collar
1
Mount the air filter
filter, to improve the seal. Mount the air filter and the filter support in the
filter box. Make sure they are centered B, and lock into place with the filter
holder

Adjusting the clutch cable

When the engine is cold the play of the clutch lever should be 10 mm (mea-
sure play at the outer end of the clutch lever).
To adjust the clutch cable push back the protection cover.
Undo the counter nut
red adjustment is achieved.
10 mm
After the adjustment process retighten the counter nut
tection cover back into place.

Adjusting the throttle cable *

6
The play of the throttle cable should be 3-5 mm at all times. To check the
play of the throttle cable push back the protection cover
grip. Now it should be possible to pull the outer sleeve of the throttle cable
3-5 mm off the throttle twist grip housing before you begin to feel a slight
resistance.
To adjust the throttle cable undo the counter nut
twist the adjustment screw
the adjustment process retighten the counter nut
tection cover is properly put back into place.
8
9
1
, swing back and remove air filter
from the filter box.
CAUTION
!
RECOMMENDS THE PRODUCTS OF THE COMPANY
. „A C "
CTION LEANER
.
TO OIL THE FOAM FILTER
A
for damage and that it is fitted correctly.
2 on the filter support
1
.
4
and twist the adjustment screw
8
until the desired adjustment is achieved. After
2
plus filter car-
!
PUTOLINE
FOR AIR FIL
„A
FOR CLEANING PURPOSES AND
3 . Grease the front side of the
5
until the desi-
4
and put the pro-
6 at the throttle
9
at the carburetor and
9
and make sure the pro-
-
CTION
19