Replacing A Hard Disk Drive - Lenovo 4262 User Manual

Replacing a hard disk drive

This section provides instructions on how to replace a hard disk drive.
To replace a hard disk drive, do the following:
1. Remove all media from the drives and turn off all attached devices and the
2. Remove the computer cover. See "Removing the computer cover" on page 13.
3. Remove the front bezel. See "Removing and reinstalling the front bezel" on
4. Locate the hard disk drive that you want to replace.
5. Disconnect the signal cable and the power cable from the rear of the hard disk
Figure 23. Removing the hard disk drive
6. Remove the failing hard disk drive from the bracket by flexing the bracket.
28
User Guide
Attention
Do not open your computer or attempt any repair before reading and
understanding the "Important safety information" in the ThinkStation Safety
and Warranty Guide that came with your computer. To obtain a copy of the
ThinkStation Safety and Warranty Guide, go to:
http://www.lenovo.com/support
computer. Then, disconnect all power cords from electrical outlets and
disconnect all cables that are connected to the computer.
page 15.
drive. Press the two tabs of the hard disk drive bracket toward each other, and
then pull the bracket outward to remove the hard disk drive with the bracket
from the chassis.