Table of Contents
Advertisement
Figure 27. Removing the optical drive bracket
32
User Guide
1. Remove all media from the drives and turn off all attached devices and the
computer. Then, disconnect all power cords from electrical outlets and
disconnect all cables that are connected to the computer.
2. Remove the computer cover. See "Removing the computer cover" on page 13.
3. Remove the PCI card holder. See "Removing and reinstalling the PCI card
holder" on page 16.
4. Your computer supports two heat sink and fan assemblies. Locate the heat
sink and fan assembly you want to replace. See "Locating components" on
page 10.
5. Depending on the heat sink and fan assembly you want to replace, do one of
the following:
v If you are replacing heat sink and fan assembly 1, go to 6.
v If you are replacing heat sink and fan assembly 2, do the following:
a. Remove the optical drive. See "Replacing the optical drive" on page 29.
b. Pivot the optical drive bracket as shown in the following illustration and
then remove it from the chassis. Go to 6.
6. Disconnect the heat sink and fan assembly cable from the system board. Note
the cable location.
Advertisement
Table of Contents
