Hitachi DZ-MV580EAU Service Manual page 40

Troubleshooting > Messages and Troubleshooting
Message
Disc is not formatted.
Format the disc now?
YES NO
Disc is not formatted.
If it formats, it becomes
possible to use for camera.
However, when you record
from PC connection
terminal, please do not
format.
Format the disc now?
YES NO
Disc overheat.
Please retry later.
DPOF is not set to scene
DPOF scenes over limit.
Cannot set DPOF scenes.
DVD-R Disc, Video mode
cannot be changed.
END OF DISC
End scene cannot be divided.
*4: The purpose of formatting DVD-R disc on the DVD video camera/recorder is to write to disc a program
exclusively for camera recording that is necessary to record images shot by camera in real time
(increasing the response from disc). When recording images that were edited using PC on DVD-R disc via
the PC connection terminal, do not format the disc: The program used exclusively for camera recording
will disable normal recording.
Cause/condition for
message to appear
Appears when an unformatted DVD-
RAM disc or one initialized (other
UDF2.0) on PC is loaded.
Also appears if user rejects partial repair
or total repair of video file.
Appears when a brand-new DVD-R disc
was loaded.
Appears when the temperature inside
the DVD video camera/recorder, or the
temperature of disc, is too high, and
normal operation cannot be executed.
Appears if "Slide Show: DPOF" is
specified when a card for which DPOF
has not been set is loaded.
Appears when the number of settable
scenes for DPOF has exceeded 999.
Appears if an attempt is made to change
the Video recording mode of a recorded
DVD-R disc. Once even one scene is
recorded on a DVD-R disc which has
been initialized, the originally
designated Video recording mode is
specified to be maintained until the final
recording on the disc.
Also appears after the DVD-R disc has
been initialized.
Appears if the disc recordable capacity
has reached the limit during recording.
Appears when the last image of scene
was selected to divide the scene: The
specifications state that dividing a scene
at its end is not possible.
4 - 14
Troubleshooting
When initializing it (deleting all
recorded data), choose "YES" and
designate it.
Choose "NO" and designate partial
repair or total repair. When
initializing it (deleting all recorded
data), choose "YES" and designate it.
When recording on the DVD video
camera/recorder, choose "YES" and
designate it. When recording video
edited on PC connected via the PC
connection terminal, choose "NO" and
designate it.
(*4)
Set the power switch to "POWER
OFF" with the disc loaded, and then
leave the DVD video camera/recorder
in a well-ventilated place until the
inside temperature decreases.
Specify "Slide Show: All", or do not
try slide show.
Release unnecessary DOPF setting
on photos when newly setting DPOF.
Stop trying to change the Video
recording mode, or replace the disc.
Operate the DVD video camera/
recorder after the message
disappears.
Replace the disc.
Stop trying to divide a scene.