Table of Contents
Advertisement
General Information
For additional security, users other than you who do not need to know your code can be
assigned different security codes. These secondary users are identified by "user numbers"
when their codes are assigned. You can assign up to 6 user codes (2-digit user numbers
03-08). Note that the master (primary) user of the system is the only one who can assign
codes to secondary users, and is designated user no. 02; user no. 01 is the installer's code.
All codes can be used interchangeably when performing system functions (a system
armed with one user's code can be disarmed by another user's code), with the exception of
the Babysitter Code described below.
Babysitter Code (User 07): This code can be used to arm the system, but cannot disarm
the system unless the system was armed with this code. This code is typically assigned to
someone (such as a babysitter) who needs to arm/disarm the system only at certain times.
The Babysitter Code is assigned to User 07.
Duress Code (User 08): This feature is intended for use when you are forced to disarm
or arm the system under threat. When used, the system will act normally, but can silently
notify the alarm monitoring company of your situation, if that service has been provided.
Duress Code is assigned to User 08.
The Duress Code is useful only when the system is connected to an alarm monitoring
company.
To Add/Delete a User or Change a User's Code
Follow the procedure for changing a user's code, but enter User No. 02 and enter the new code
twice.
IMPORTANT: Temporary users of the system (e.g., babysitters, cleaning staff) should not be
shown how to use any system function they do not need to know, such as bypassing protection
zones for example.
Sequential key depressions for all steps in a procedure must be made within 2 seconds of
one another, or else the entire entry is aborted and must be repeated from its beginning.
Add a user code:
Delete a user code:
Wait (about 3 seconds) until the keypad beeps once before pressing any other key. The
code is automatically deleted.
Changing the Master Code
+
Key + user number (03-08) + user's code
CODE
Master Code
+
CODE
Master Code
– 25 –
Security Codes
Key + user number (03-08)
Advertisement
Table of Contents
