Control Panel Mounting - Guest 502-1 Installation And Operation Instructions Manual

CAUTION: Always wear eye protection when using power tools!
3. Bring the control cable coming from the spotlight out through the control panel , and
make the connections as shown on page 4 or 5.
4. Feed the spliced cable back into the cutout hole. Test fit the control panel and use a
pencil to mark the locations of the two small holes in the panel onto the mounting
surface. Remove the control panel, then drill a 3/32" (1mm) pilot hole at each of the
marked locations.
5. Apply a small amount of sealant, (such as StarBrite® Boat Caulk #83801), to the back
of the control panel face plate. Fit the control panel into the hole, and fasten the
control panel onto the surface with the two Stainless Steel Phillips pan head self-
tapping screws provided w/control.
Electrical Connections
Guest models 502-1, 502-4 and 503-1 lights have two types of wiring connections.
They are:
Power supply wires - the larger red (+ + + + ) and black (− − − − ) wires that bring 12 volts DC
•
power to the light and to the control panel.
Control cable wires - the small wires within a gray casing that carry your
•
commands from the control panel to the spotlight.
(38mm)
2.25"
(57mm)

Control panel mounting

3
1.5"