Advertisement
Advertisement
Table of Contents
Related Manuals for Guest 502-1
Summary of Contents for Guest 502-1
- Page 1 ® ® MODEL 502-1 Spotlight with joystick control panel MODEL 503-1 Spot/Flood light with joystick control panel MODEL 502-4 Spotlight INSTALLATION AND OPERATION INSTRUCTIONS IMPORTANT! READ THESE INSTRUCTIONS BEFORE INSTALLING AND USING THIS PRODUCT. KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE.
-
Page 2: Installation
Description The GUEST 502-1 and 502-4 Spotlights use a 100 watt halogen bulb to produce a tightly focused beam which can illuminate objects up to 1 mile away. The GUEST 503-1 Spot/Flood light uses a revolutionary dual-focus halogen bulb. Select the 100 watt, narrow-beam spotlight for illuminating objects up to 1 mile away or the 55 watt wide-area floodlight for docking and deck lighting. - Page 3 Avoid running the cable across sharp edges or where it may be exposed to extreme heat. Mounting the Control Panel (Models 502-1 & 503-1 only) 1. Select a convenient mounting location for the control panel. Be sure that you will have access to the area behind the location, and that you can drill holes there without damaging existing wiring or structures.
-
Page 4: Control Panel Mounting
Electrical Connections Guest models 502-1, 502-4 and 503-1 lights have two types of wiring connections. They are: Power supply wires - the larger red (+ + + + ) and black (− − − − ) wires that bring 12 volts DC •... - Page 5 If the light will be less than 30 feet (9M) from its power source, use 12 gauge (3mm) wires. If the distance will be more than 30 feet (9M), use 10 gauge (5mm) wires. 502-1 Spotlight Wiring Diagram Foam Gasket 10-12 ga.
-
Page 6: Operation
503-1 Spot/Floodlight Wiring Diagram Foam Gasket 10-12 ga. (5mm) crimp Connector 12 volts DC 10 Amp Fuse Black (or circuit breaker) 12 volts DC Connect the wires from the spotlight to SAME wire colors of provided cable Male Plugs on this end of cable Connect the control cable wires to SAME wire colors of provided cable... - Page 7 Relay PC board - (503-1) U-3383 Extension Cable Kit (All) 729528 Dual station kit (502-1) 729488 Dual station kit (503-1) 729491 NOTE: THE CONTROL PANEL USED WITH GUEST MODEL 500 & 501 WILL NOT OPERATE MODELS 502-1, 502-4 or 503-1.
- Page 8 If your light has a problem that is not described above, return the unit to the Guest Service Department for a free examination. Be sure to include a brief description of the problem, proof of purchase (if requesting warranty service), and your daytime telephone and/or fax number.
-
Page 9: Limited Warranty
LIMITED WARRANTY For one (1) year from the date of purchase, The Guest Co. will, at its' discretion, repair or replace for the original consumer, free of charge, any part or parts found upon examination by Guest Co., 95 Research Parkway, Meriden, Connecticut, USA to be defective in material or workmanship or both.