Using The Osd Menu - Dell SP2008WFP User Manual

The Menu button is used to open and exit the on-screen display (OSD), and exit from menus and sub-menus. See
Using the OSD
OSD menu / select
Use these buttons to adjust (decrease/increase ranges) items in the OSD menu.
Down (-) and Up (+)
Use this button to launch Brightness menu.
Brightness Menu
Use this button to activate automatic setup and adjustment. The following dialog appears on a black screen as the
monitor self-adjusts to the current input:
Auto Adjust
Auto Adjustment
Adjustment, you can further tune your monitor by using the Pixel Clock (Coarse), Phase (Fine) controls in the OSD.
Use the power button to turn the monitor on and off.
The blue light indicates the monitor is on and fully functional. An amber light indicates power save mode.
Power Button and Indicator

Using the OSD Menu

NOTE: If you change the settings and then either proceed to another menu, or exit the OSD menu, the monitor automatically saves those
changes. The changes are also saved if you change the settings and then wait for the OSD menu to disappear.
1. Press the Menu button to open the OSD menu and display the main menu.
Main Menu for Auto Detect Analog (VGA) Input
Menu.
button allows the monitor to self-adjust to the incoming video signal. After using Auto
NOTE: Auto Adjust does not occur if you press the button while there are no active video input signals or
attached cables.
or
Auto Adjust In Progress
Main Menu for Auto Detect Digital (DVI) Input