Cleaning The Air Filter Screen; Fuel Cap/Sparking Plug; Attaching The Hanger Cap; Storage - Ryobi RLT30CESA Original Instructions Manual

CLEANING THE AIR FILTER SCREEN (Fig. 9)
For proper performance and longer life, keep the air filter
screen clean.
■ Remove the air filter cover by pushing down the latch
while gently pulling out the cover.
■ Brush the air filter screen lightly.
■ Replace the air filter cover by inserting the tabs of the
cover into the slots on the air filter base, then push
the cover up until it latches securely in place.
FUEL CAP
WARNING
A leaking fuel cap is a fire hazard and must be
replaced immediately.
SPARKING PLUG (Fig. 10)
This engine uses a Champion RCJ-6Y or equivalent
spark plug with 0.63 mm electrode gap. Use an exact
replacement and replace annually.
ATTACHING THE HANGER CAP (Fig. 12)
To use the hanger cap, push in the button and place the
hanger cap over the lower end of the attachment. Slightly
rotate the cap from side to side until the button locks into
place.
NOTE: The secondary hole in the attachment shaft can
be used for hanging purposes as well.
STORAGE (1 MONTH OR LONGER)
Drain all fuel from tank into a container approved
n
for fuel. Run engine until it stops.
Clean all foreign material from the trimmer. Store it in
n
a well-ventilated place that is inaccessible to children.
Keep away from corrosive agents such as garden
chemicals and de-icing salts.
Abide by all ISO and local regulations for the safe
n
storage and handling of fuel. Excess fuel should be
used up in other 2-stroke engine powered equipment.
WARNING
Inspection after dropping or other impacts:
Thoroughly inspect the product and identify
any affections or damage with it. Any part that
is damaged should be properly repaired or
replaced by an authorized service centre.
English (Original Instructions)
8