Monthly Checks; Bubble Maintenance - Siemens Solaris CCDS1415-ST Configuration Manual

13.2

Monthly checks

13.3

Bubble maintenance

Siemens Building Technologies
Fire Safety & Security Products
NOTE
If necessary, refit the dust cap attached to the lanyard - to avoid corrosion of the connector terminals.
5. Unhook the Dome from its mounting bracket.
Visually check the mounting bracket for signs of defect or corrosion.
Check the cable runs between the Dome unit and External Telemetry Unit for
security of attachment and signs of wear.
Check all mechanical fixings to the building infrastructure for corrosion, wear and
rigidity.
Issue the customer a written report of any defects (which are beyond the scope
of CCTV maintenance) in the building infrastructure or other equipment.
Check that the Solaris™ Dome / camera is functioning correctly for:
Full range of movement, bearing in mind any 'soft limits' that may have been
–
set.
Slow and fast speeds.
–
Picture quality.
–
Clean the bubble if necessary. See 'Bubble Maintenance'.
Check fan speed (Diagnostic menu). Although the fan speed changes
depending on temperature, it should always run above 50% speed.
Perform camera lens initialise, followed by a camera reset. See Reset menu in
Section 11.1.2: The Camera menu.
When handing the bubble, always hold the outer flange if possible. Handle with
extreme care as the bubble is easily scratched.
Under no circumstances should you touch the inner surface of the bubble.
If debris is present on the inner surface, do not wipe it with a cloth. Blow the
debris out of the bubble using a filtered air line or a can of compressed air
(available from electronics suppliers, e.g. RS).
Small scratches or scuffs can be removed from the outer surface with the use of
a suitable cloth and metal polish (brass cleaner).
69
08.2006