Direct Control Via Cka48Xx/Cka32Xx - Siemens Solaris CCDS1415-ST Configuration Manual

12.3.1 Direct control via CKA48xx/CKA32xx

Operation
Pan Left (variable speed)
Pan Right (variable speed)
Tilt Up (variable speed)
Tilt Down (variable speed)
Focus Near
Focus Far
Zoom In
Zoom Out
All Stop
OSD Setup On
AutoFocus On
Flip
Toggle Colour / B&W
Pattern Record
Pattern Stop
Pattern Save
Pattern Test
Exit OSD menu
Store Preset 1-64
Recall Preset 1-64
Enter OSD menu
Exit OSD
Go to Home position
Flip
Start Auto Patrol
BLC On
BLC Off
One Push White Balance
One Push AutoFocus
Display Version
Setup privacy zone
IR Cut Filter On ("Night
Mode")
IR Cut Filter Off ("Day Mode") 78 Pos
Stop Scan
Random Scan
Frame Scan
Auto Scan
Record / Recall Pattern 1
58
Siemens Building Technologies
Fire Safety & Security Products
NOTE
We recommend following interfacing:
RS485 connection, 9600 baud, even parity, 8 data bits, 1 stop bit
Camera addressing is 0-127
Tested using Siemens keyboard CKA4820
User Notes
keyboard
action
Pan Left
Pan Right
Tilt Up
Tilt Down
Focus Near
Focus Far
Zoom In
Zoom Out
Cam + Stop
Cam + F1 Also available by Pos 65. When opening the OSD with "Cam" + F1 it is necessary to exit
the OSD with "Cam" + F10. It is possible to exit the OSD menu by selecting the EXIT
option in the OSD main menu. If so, the keyboard will remain in menu mode (green LED
flashing). It is necessary to use "Cam" + F10 to exit menu mode on the keyboard in that
case. Also Solaris™ will automatically exit the OSD mode after approx. 2 minutes of no
activitiy. In this case it is necessary to use "Cam" + F10 to exit menu mode on keyboard.
Cam + F2
Cam + F3
Cam + F4 This function will toggle the automatic D/N function if preset.
Cam + F6 Enters pattern record mode for pattern 1 (direct).
Cam + F7 Ends pattern record mode for pattern 1 (direct).
Cam + F8 Ends pattern record mode pattern 1 and saves (direct).
Cam + F9 Recalls the last pattern recorded (direct).
Cam + F10
[1...64] Mem
[1...64] Pos
65 Pos Also available using Cam+F1.
66 Pos Also available using Cam+F10.
67 Pos Home is Preset 1 on Solaris™.
68 Pos
69 Pos Starts preset tour.
70 Pos
71 Pos
72 Pos
73 Pos
74 Pos Displays Dome and XTU firmware versions.
76 Mem
77 Pos
83 Pos Stops current sequence / tour / pattern.
84 Pos Starts random preset tour.
85 Pos Starts preset sequence (fixed speed, uniform dwell time).
86 Pos Starts preset tour.
87 Mem / Pos Starts recording or playing Pattern 1.
08.2006