DeWalt XR-LI-ION DCV582-XE Instruction Manual page 12

Cleaning
WARNING: Blow dirt and dust out of all air vents with clean, dry air at least once
a week. To minimize the risk of eye injury, always wear AS/NZS1337 approved eye
protection when performing this.
WARNING: Never use solvents or other harsh chemicals for cleaning the
non-metallic parts of the tool. These chemicals may weaken the plastic materials
used in these parts. Use a cloth dampened only with water and mild soap. Never let
any liquid get inside the tool; never immerse any part of the tool into a liquid.
CHARGER CLEANING INSTRUCTIONS
WARNING: Shock hazard. Disconnect the charger from the AC outlet before
cleaning. Dirt and grease may be removed from the exterior of the charger using a
cloth or soft non-metallic brush. Do not use water or any cleaning solutions.
Repairs
This charger and battery pack are not serviceable. Servicing at an authorized service
centre is required to avoid damage to static sensitive internal components.
To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment
(including brush inspection and replacement) should be performed by certified
service centers or other qualified service organizations, always using identical
replacement parts.
Accessories (Fig. 7)
WARNING: Since accessories, other than those offered by D
tested with this product, use of such accessories with this tool could be hazardous.
To reduce the risk of injury, only D WALT recommended accessories should be used
E
with this product.
The DCV582 includes a 1-1/4" hose, crevice tool (stored in the handle) and wide
nozzle.
The replacement filter (DCV5801H-XJ) and air-lock adapter (DWV9000-XJ) are
available as accessories at additional cost.
Cord, Hose and Accessory Storage (Fig. 2)
When the vacuum is not in use, the power cord should be secured around the
vacuum handle underneath the cord wrap (J). The vacuum hose can be wrapped
around appliance, underneath the battery interface, and secured with the hose clip (G)
also located at the back of the vacuum. The two accessories (crevice tool and wide
nozzle) can be stored on board the vacuum as well.
Recommended accessories for use with your tool are available at extra cost from
your local service center. If you need any assistance in locating any accessory, please
contact Stanley Black & Decker, 82 Taryn Drive, Epping, VIC 3076 Australia or call
1800 338 002 or (NZ) 0800 339 258.
WALT, have not been
E
10