Vacuum Cleaning - DeWalt XR-LI-ION DCV582-XE Instruction Manual

OPERATION
WARNING: To reduce the risk of injury, turn unit off,
disconnect it from power source and remove the battery
before installing and removing accessories, before
adjusting or when making repairs. An accidental start-up
can cause injury.
Installing and Removing the Battery Pack
(Fig. 3)
NOTE: Make sure your battery pack is fully charged.
To install the battery pack into the vacuum, insert/slide
battery into battery port (A). Make sure the battery pack is
fully seated.
To remove the battery pack from the vacuum, press and hold the battery release
on the battery pack and remove battery. To charge battery, insert it into your D
charger.
FUEL GAUGE BATTERY PACKS (FIG. 4)
Some D WALT battery packs include a
E
fuel gauge which consists of three green
LED lights that indicate the level of charge
remaining in the battery pack.
To actuate the fuel gauge, press and hold
the fuel gauge button (K). A combination
of the three green LED lights will illuminate
designating the level of charge left. When
the level of charge in the battery is below the usable limit, the fuel gauge will not
illuminate and the battery will need to be recharged.
NOTE: The fuel gauge is only an indication of the charge left on the battery pack.
It does not indicate tool functionality and is subject to variation based on product
components, temperature and end-user application.
For more information regarding fuel gauge battery packs, please contact Stanley Black
& Decker, 82 Taryn Drive, Epping, VIC 3076 Australia or call 1800 338 002 or (NZ)
0800 339 258.
FIG. 3
A
WALT
E
FIG. 4
K
Using the Appliance (Fig. 5)
1 Attach the appropriate accessory to the hose (B).
2. Insert D WALT battery pack or plug into a 230V wall
E
outlet.
3. To turn machine on, press the I/O (on/off) button (C).
WARNING: If foam or liquid escapes from the machine, switch off immediately.

Vacuum Cleaning

TO EMPTY TANK (FIG. 6)
The sound of the motor changes and suction is
reduced when the tank is full.
1. Turn machine off. Unplug it from any
power source, and remove the battery
pack.
2. Unlatch tank latches (D) and remove
power head from the tank.
3. Empty contents of tank into suitable
container.
4. Clean or change filter (E). See Filter
section of this manual.
5. Inspect machine for damage by foreign
objects. Contact the nearest D WALT
E
authorized service center for replacement of damaged or missing parts.
6. Replace power head onto the tank and latch securely.
NOTE: The machine must be used in the upright position at all times to prevent unwanted
actuation of the Automatic Vacuum Shutoff. If unwanted actuation should happen, turn off
the motor and wait until the motor stops turning. Turn the motor on again and suction will
be restored.
8
FIG. 5
FIG. 6
E
D