Battery Recharge - Panasonic KX-TG2711SA Operating Instructions Manual

Problem
I cannot hear a dial tone.
I cannot use the intercom
or phonebook copy feature.
Programmable settings
Problem
The display is in a
language I cannot read.
I cannot activate the eco
mode.

Battery recharge

Problem
The handset beeps and/or
flashes.
I fully charged the
batteries, but
– still flashes or
– the operating time
seems to be shorter.
Making/answering calls, intercom
Problem
is flashing.
TG2711_13SA(en)_0927_ver001.pdf
Cause/solution
R Make sure that you are using the supplied telephone line cord.
Your old telephone line cord may have a different wiring
configuration.
R The base unit's AC adaptor or telephone line cord is not
connected. Check the connections.
R Disconnect the base unit from the telephone line and connect
the line to a known working telephone. If the working
telephone operates properly, contact our service personnel to
have the unit repaired. If the working telephone does not
operate properly, contact your service provider/telephone
company.
R These features are available between the handsets. Although
the handset displays "Intercom", "Copy All", or "Copy",
these features are not available for single handset models.
Cause/solution
R Change the display language (page 11).
R You cannot set eco mode when you set the repeater mode
"On". If required, set the repeater mode to "Off" (page 19).
Cause/solution
R Battery charge is low. Fully charge the batteries (page 8).
R Clean the battery ends (
a dry cloth and charge again.
R It is time to replace the batteries (page 8).
Cause/solution
R The handset is too far from the base unit. Move closer.
R The base unit's AC adaptor is not properly connected.
Reconnect AC adaptor to the base unit.
R The handset is not registered to the base unit. Register it
(page 29).
R Activating one touch eco mode reduces the range of the base
unit in standby mode. If required, turn eco mode off (page 12).
27
Useful Information
, ) and the charge contacts with
2012/09/27 12:18:21
27