When multiple Cisco Unified Wireless LAN Controllers are to be in the same mobility group, then the IP address and MAC
address of each Cisco Unified Wireless LAN Controller should be added to the Static Mobility Group Members configuration.
802.11 Network Settings
If using 5 GHz, ensure the 802.11a network status is set to enabled.
Set the beacon period to 100ms.
Ensure DTPC Support is enabled.
If using 802.11n capable access points, ensure ClientLink is enabled.
Configure 12 Mbps as the mandatory (basic) rate and 18 – 24 or 54 Mbps as supported (optional) rates.
36-54 Mbps can optionally be disabled, if there are not any applications that can benefit from those rates.
Enable CCX Location Measurement.
Cisco Unified IP Phone 9971 Wireless LAN Deployment Guide
47