Table of Contents
Advertisement
INTRODUCTION
Another example of a typical screen is this:
This shows a list of parameters. To change any of them, move the cursor to the one you wish to
change and use the DATA ENTRY +/- keys to select a new value. In cases where there are many
options to select, the DATA +/- keys are 'accelerators' that speed up the longer you press them.
However, it is not always necessary to use the cursor keys to move up and down parameter lists
and some pages offer a more direct approach to parameter selection. For example:
In this example, INSERT, you can select the clipboard to insert from simply by pressing any of the
numeric keypad's number keys 0-9. You can specifically move the cursor to the REFERENCED
TO field if you wish to select IN, SYNC or OUT with the DATA ENTRY +/- keys but you can achieve
this more easily by just pressing the IN, SYNC or OUT keys - the display will change accordingly,
showing your selection. You can also see a '?' softkey. This conveniently 'toggles' selects the SLIP
TYPE parameter.
TRACK ZOOM KEYS
The CURSOR keys are also used with the SHIFT key to zoom in and out on tracks.
SHIFT plus the CURSOR
simultaneously to switch between maximum horizontal zoom in and a zoom out of your choice by
pressing SHIFT+CURSOR
choice - pressing SHIFT and the CURSOR
level and maximum zoom.
SHIFT plus the CURSOR
in, showing fewer and fewer tracks whilst SHIFT+ will zoom out, showing more tracks. As you
zoom in, so you will see tracks 1-24, 1-16, 1-12, 1-8, 1-4, 1-2 and finally, 1 displayed on the
external monitor.
SCROLL VIEW KEYS
When the display is zoomed in, you may want to view different tracks to the ones shown on the
screen. This can be done using the SCROLL VIEW
tracks. For example, if the display is currently zoomed in to display tracks 1-4, pressing SCROLL
VIEW
will scroll the display to show tracks 5-8.
In the SHOW ON VGA monitor page, you may set the RE32 so that tracks selected for edit are
those that are shown on the VGA as you zoom in. For example, with tracks 3 and 4 selected for
edit, when you zoom to two tracks, 3 and 4 would automatically be placed at the top of the screen.
Please see the section that describes the SHOW functions for more details on this.
The SCROLL VIEW keys are also used with the SHIFT key to increase or decrease the waveform
magnification on the external monitor.
16
allow horizontal zoom in/out. You may also use these keys
keys simultaneously. To do this, zoom in to the level of your
keys together will now switch you between that
keys allow you to zoom in vertically on tracks. SHIFT+ will zoom
keys to scroll up or down to the required
Version 1.00
Advertisement
Table of Contents
