Akai RE32 Operator's Manual page 106

EDIT TOOLS
Pressing XFADE (F1) on the CROSSFADE TOOLS page takes you to this screen:
The parameters are:
AMOUNT
METHOD
ADJUST
Having set the required parameters, press the EXECUTE key to proceed.
96
The amount by which the two cues are to overlap.
The method by which the overlap is to be achieved (TRIM or SLIP) and
may be selected either using the DATA ENTRY +/- keys or more directly
using F1 and F2.
When TRIM is selected, one or both of the cues will be extended; this
assumes that the cue in question has a handle available for extension.
Note that the targeted cue turns yellow, while the passive cue stays
green.
With SLIP selected, either the PRE or the POST cue (not BOTH) is
actually moved along the timeline. SLIP IN can also be selected from
within the TRIM page by pressing the IN key while pressing SHIFT.
Similarly, OUT + SHIFT selects SLIP OUT.
SLIP mode is clearly dangerous if working to picture, hence the cues in
question turn red in warning. Note that, when SLIP is selected F3
becomes active as SLIP? and toggles between slipping just the cue or
the entire track:
Selects which point(s) is to be adjusted:
PRE (F4) Selects the PRE point for adjustment.
POST (F5) Selects the POST point for adjustment.
BOTH (F6) Selects both PRE and POST points for adjustment.
Version 1.00