ViewSonic VX1935wm-3 Service Manual page 13

"On" when power is restored after a power failure. If the power button is not in the locked mode, then power should
return to it's previous state when power is restored after a power failure. The power button lock will be deactivated by
pressing the front panel control buttons "(1), & (▼)" again for 10 seconds.
Note 1: Status bar indicating Power Button lock or unlock is in progress and when complete it will indicate "Power
Button Locked"
Note 2: Power should only be lockable in the "On State"
Memory Recall Actions
Memory Recall action on the analog and digital mode as below
1. Recall white balance to factory setting
2. Set the factory defaults as shown in Section 4-8
3. Clean all the mode setting buffer
4. Execute Auto Image Adjust
Note: Memory Recall should have no effect for Language, Power Lock, User Color Settings or Input Priority
Resolution Notice Actions
1. Resolution Notice OSD should show on screen after changing to non-native mode for 30 sec
2. For auto input select function, it shall meet the requirement in Appendix D.
3. The OSD should disappear after 10 sec or by pushing button [1] or [2]
Resolution Notice function should be disabled when push button [2] under Resolution Notice OSD
0-Touch™ Function Actions
1. Execute Auto Image Adjust when new mode detected, and save the settings to buffer for further use
2. It should be reset by Memory Recall function(Should not reset by power off, power unplug and others)
OSD Auto Save
The OSD shall save new settings when it is turned off by the user or when it times out. There shall not be a
separate save
Factory Defaults
Item
Contrast
Brightness
Color Temperature
Sharpness
OSD H. Position
OSD V. Position
OSD Time Out
OSD Background
ViewSonic Corporation
Defaults
70%
100% Resolution Notice
6500K
100%
50%
50%
15 Sec
Enabled
10
Item
Input Priority
Volume
Balance
Treble
Bass
Confidential - Do Not Copy
Defaults
N/A
Enabled
N/A
N/A
N/A
N/A
VX1935wm-3