Controller Position - Pride Quantum 610 Series Owner's Manual

V . C O M F O R T A D J U S T M E N T S
To change the armrest width:
1. Locate the two armrest knobs on each side of the
armrest receiver bracket. See figure 14.
2. Loosen the knobs.
3. Slide the armrests in or out to the desired width.
4. Tighten the knobs.
Armrest Angle Adjustment
To change the armrest angle:
1. Lift the armrest straight up so that it is perpendicular
to the floor. See figure 14.
2. Loosen the jam nuts.
3. Turn the adjusting screw to raise or lower the front
of the armrest.
4. Tighten the jam nuts to lock the adjusting screw into
place.

Controller Position

You can move the controller in toward or out away from the armrest, or change the position of the controller for
either left-hand or right-hand use.
MANDATORY! Do not place the controller harness so that it can be pinched in the seat frame or
the power base frame.
To extend the controller:
1. Flip up the armrest so it is perpendicular to the floor.
2. Loosen the setscrew on the controller bracket. See figure 15.
3. Slide the controller into or out of the armrest to the desired position.
4. Tighten the setscrew to secure the controller.
To change the controller position:
1. Turn off the power to the controller.
2. Loosen the rear shroud fasteners and remove the rear shroud.
3. Unplug the controller connector from the power base.
4. Remove any wire ties securing the controller harness to the armrest.
5. Flip up the armrest so it is perpendicular to the floor.
6. Loosen the setscrew on the controller bracket
7. Slide the controller out of the armrest.
8. Loosen the setscrew in the other armrest.
9. Place the controller in the other armrest.
10. Tighten the setscrew to secure the controller.
11. Route the controller harness to the back of the power base and plug in the controller.
12. Replace the rear shroud and tighten the fasteners.
13. Secure the controller harness to the armrest with wire ties. See figure 9.
NOTE: If your power chair is equipped with a Specialty Seat, Synergy Seat, or TRU-Balance Power Positioning
System, refer to the information provided in supplemental manuals provided with your seating system.
16
Figure 15. Underside of Armrest
www.pridemobility.com
SETSCREW
Quantum 610 Series